TL V6-3.5L (2007)
10. Turn the center screw (C) on the pressure plate compressor counterclockwise by hand to release the pressure, then remove the pressure plate
compressor (D), clutch alignment shaft (E), pressure plate compressor adapter (F) and ring gear holder (G).
11. Make sure the diaphragm spring fingers are all the same height.
Release Bearing Replacement
1. Remove the release fork boot (A) from the clutch housing (B).
2. Remove the release fork (C) from the clutch housing by squeezing the release fork set spring (D). Remove the release bearing (E).
3. Check the play of the release bearing by spinning it with your hand. If there is excessive play or noise, replace the release bearing.
NOTE: The release bearing is packed with grease. Do not wash it in solvent.
4. Apply super high temp urea grease (P/N 08798-9002) to the release fork (A), the release fork bolt (B), and the release bearing (C), in the shaded
areas, then set the release fork set spring (D).
