TL V6-3.5L (2007)
2. Install the inboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to damage the inboard boot.
3. Install the spider (A) onto the driveshaft by aligning the marks (B) you made on the spider and the end of the driveshaft.
4. Install the new circlip (C) into the driveshaft groove. Rotate the circlip in its groove to make sure it is fully seated.
5. Fit the rollers (A) onto the spider (B) with the high shoulders facing outward and note these items:
^
Reinstall the rollers in their original positions on the spider by aligning the marks (C) you made.
^
Hold the driveshaft pointed up to prevent the rollers from failing off.
6. Pack the inboard joint with the joint grease included in the new inboard boot set.
