TL V6-3.5L (2007)
13. Install the boot band on the other end of the boot, and repeat steps 11 and 12.
14. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot (B).
NOTE: Pass the end of the new double loop band through the clip (C) twice in the direction of the forward rotation of the driveshaft.
15. Pull up the slack in the band by hand.
16. Mark a position (A) on the band 10-14 mm (0.4-0.6 in.) from the clip (B).
17. Thread the free end of the band through the nose section of the commercially available boot band tool KD-3191 or equivalent (A), and into the slot
on the winding mandrel (B).
