TL V6-3.5L (2007)
12. Attach the molding (A) with adhesive tape (B) to the upper edge of the windshield (C). Be careful not to touch the windshield where adhesive will
be applied.
13. Attach the molding upper seal (A) to the inside surface of the molding (B) as shown.
14. Set the windshield in the opening, and center it. Make alignment marks (A) across the windshield and body with a grease pencil at the four points
shown. Make sure both clips (B) contact the edge of the body holes. Be careful not to touch the windshield where adhesive will be applied.
15. Remove the windshield.