TL V6-3206cc 3.2L SOHC MFI (1998)
2. Assemble the thrust needle bearing, needle bearing, and 4th gear, and install the 43 x 74 mm thrust washer using the special tool and a press as
shown.
NOTE: Replace the 43 x 74 mm thrust washer, if it can be installed by pressing with your hand.
3. Spin mainshaft 4th gear by hand to check for clearance. The clearance is normal if it turns freely without binding.
4. Remove the mainshaft bearing from the transmission housing.
5. Assemble the parts below on the mainshaft.
NOTE: Do not assemble the O-rings and mainshaft 1st gear.
6. Torque the mainshaft locknut to 29 Nm (22 ft. lbs.).
7. Move the 1st/4th clutch assembly to check the axial clearances.
