TL V6-3206cc 3.2L SOHC MFI (1998)
8. Measure the clearance between the 1st/4th clutch guide and 1st gear collar with a feeler gauge.
-
STANDARD: 0 - 0.8 mm (0 - 0.003 inch).
NOTE: Take measurements in at least three places and use the average as the actual clearance.
9. If the clearance is out of tolerance, remove the 43 x 74 mm thrust washer, and measure the thickness.
NOTE: If the 0.08 mm (0.003 inch) feeler gauge can be inserted, perform this step.
10. Select and install a new 43 x 74 mm thrust washer, then recheck.
11. After replacing the 43 x 74 mm thrust washer, make sure that the clearance is within the tolerance.