TL AWD V6-3.7L (2010)
10. Disconnect the latch cable (A) and the inner handle cable (B) from the latch (C).
11. Install the latch in the reverse order of removal, and note these items:
-
Before reinstalling the latch protector, clean the latch and the latch protector surfaces with isopropyl alcohol where the new foam seals will be
attached.
-
After reinstalling the latch protector to the latch, attach the new foam seals to the protector and the latch.
-
Push the hook into place securely.
-
Make sure the actuator connector is plugged in properly, and the rod and the cables are connected securely.
-
Make sure the power door locks and opens properly.
-
When reinstalling the door panel, make sure the plastic cover on the door is installed properly .