TL AWD V6-3.7L (2010)
2. Loosely install the new subframe middle mounting bolts (F, G) securing the subframe middle mounts (H).
3. Insert the subframe alignment pin (I) through the positioning slot (J) on the right rear stiffener, through the positioning hole (K) on the
subframe, and into the positioning hole (L) on the body, then loosely tighten the subframe right rear mounting bolt.
4. Insert the subframe alignment pin through the positioning slot on the left rear stiffener, through the positioning hole on the subframe, and into
the positioning hole on the body, then loosely tighten the subframe left rear mounting bolt.
5. Tighten the subframe mounting bolts to the specified torque values starting with the right rear subframe mounting bolt. Use the subframe
alignment pin when tightening the rear side subframe mounting bolts.
6. Check all of the subframe mounting bolts, and retighten if necessary.
NOTE: Tighten the bolts in the sequence shown.
2. Tighten the bolts securing the subframe middle mounts to the specified torque.
3. After reinstalling all removed parts, check and adjust the front wheel alignment See: Maintenance/Alignment/Service and Repair.
Rear Subframe Torque
NOTE:
-
Install the rear subframe by aligning the installation positioning holes and positioning holes with the subframe alignment pin.
-
Always replace any removed subframe mounting bolts with new ones.
