TL AWD V6-3.7L (2010)
Trim Panel: Service and Repair
C-Pillar Outer Trim Replacement
C-Pillar Outer Trim Replacement
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program
NOTE:
-
Take care not to scratch the trim or the body.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Open the rear door.
2. Pry up on the edge of the C-pillar outer trim (A) with a trim tool to detach the clips, then remove the trim.
3. Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Make sure you cannot see the EPT foam (B) from outside.
-
Push the clips into place securely.
