TL AWD V6-3.7L (2010)
3. Remove the brake pads See: Brake Pad/Service and Repair/Front Brake Pad Inspection and Replacement.
4. Using a micrometer, measure the brake disc thickness at eight points, about 45 ° apart and 10 mm (0.39 in) in from the outer edge of the brake
disc. Replace the brake disc if the smallest measurement is less than the max. refinishing limit.
NOTE: This is the maximum allowable difference between the thickness measurements.
5. If the brake disc is beyond the service limit for parallelism, refinish the brake disc with a Honda-approved commercially available on-car brake
lathe.
NOTE: If the brake disc is beyond the service limit for refinishing, replace it See: Service and Repair/Front Brake Disc Replacement.
6. Install the brake pads See: Brake Pad/Service and Repair/Front Brake Pad Inspection and Replacement.
7. Clean the mating surfaces between the brake disc and the inside of the wheel, then install the front wheels.