TL AWD V6-3.7L (2010)
Brake Master Cylinder: Service and Repair
Brake Master Cylinder Replacement
NOTICE
-
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.
-
Be careful not to damage or bend the brake lines during removal and installation.
-
After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.
1. Remove the engine compartment covers (A) in the engine compartment See: Body and Frame/Access Cover/Service and Repair.
2. Remove the strut brace See: Body and Frame/Frame/Structural Brace/Service and Repair.
3. Remove the under-hood fuse/relay box mount nut (A) and release the clip (B).
4. Remove the harness clamp (C), then move the under-hood fuse/relay box (D) aside.
5. Remove the reservoir cap and the brake fluid from the master cylinder reservoir with a syringe.
6. Disconnect the brake fluid level switch connector (A).