TL AWD V6-3.7L (2010)
7. Disconnect the brake lines (B) from the master cylinder (C). To prevent spills, cover the hose joints with clean rags or shop towels.
8. Remove the master cylinder mounting nuts (D) and the washers (E).
9. Remove the master cylinder from the brake booster (F). Be careful not to bend or damage the brake lines when removing the master cylinder.
10. Remove the rod seal (G) from the master cylinder.
NOTE: During installation, set a new rod seal onto the master cylinder with its grooved side (H) toward the master cylinder.
11. Install the master cylinder with a new rod seal in the reverse order of removal, and note these items:
-
Coat the inner bore lip and the outer circumference of the new rod seal with the Shin-Etsu silicone grease (P/N 08798-9013).
-
Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your
hands or gloves.
-
Check the brake pedal height and free play after installing the master cylinder, and adjust it if necessary See: Brake Pedal Assy/Adjustments.
12. Bleed the brake system See: Brake Bleeding/Service and Repair.
13. Spin the wheels to check for brake drag.
