TL AWD V6-3.7L (2010)
5. Insert the camshaft (B) into the cylinder head, then install the camshaft thrust cover (C). Always use a new O-ring (D). Apply new engine oil to the
journals and the cam lobes.
6. Check that the oil seal lips are not distorted.
7. Install the hollow dowel pin (E).
8. If the rocker arm assembly is disassembled, reassemble the rocker arm assembly See: Camshaft, Lifters and Push Rods/Rocker Arm
Assembly/Service and Repair/Overhaul.
9. Remove all of the old liquid gasket from the rocker shaft holder and the cylinder head.
10. Apply liquid gasket, P/N 08717-0004, 08718-0003, or 08718-0009 to the rocker shaft holder mating surface of the cylinder head. Install the
component within 5 minutes of applying the liquid gasket.
NOTE:
-
Apply a 2.5 mm (0.098 in) diameter bead of liquid gasket along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply the new liquid gasket.
