TL AWD V6-3.7L (2010)
weight sensor with the HDS.
While doing the initialization of the ODS unit, observe these precautions:
-
Before initializing the front passenger's weight sensor, make sure the battery is fully charged.
-
Make sure all components of the front passenger's seat are correctly installed.
-
Make sure nothing is the front passenger's seat.
-
Make sure there is nothing in the front passenger's seat-back pocket.
-
Keep the windows and the moonroof closed.
-
Do all initialization procedures, except test-driving, in the service bay.
-
Make sure the vehicle is on level ground.
-
Keep the A/C and the heater off.
-
Do not touch the front passenger's seat during initialization, until you are prompted to or when you have completed the initialization.
-
Do not expose the front passenger's seat to sudden temperature changes.
1. Position the front passenger's all the way rearward, and adjust the seat-back to the forward most position. Do not move the seat from this position
until the initialization is completed.
2. Make sure the ignition switch is in LOCK (0), or press the engine start/stop button to select the OFF mode.
3. Connect the HDS to the data link connector (DLC) (A).
4. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
5. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/DLC Circuit Troubleshooting.
6. Drive the vehicle, and accelerate to 20 mph (36 km/h), then stop on level ground.
7. From the HDS Main Menu, select SRS, then INITIALIZATION. In the INITIALIZATION Menu, select SWS Initialization. Follow the prompts
until the front passenger's weight sensor initialization has been completed.
8. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
9. Disconnect the HDS from the DLC.
