TL AWD V6-3.7L (2010)
Installation
NOTE:
-
If replacing the side curtain airbag after deployment, refer to Component Replacement/Inspection After Deployment See: Service and Repair for
a complete list of other parts that must also be replaced.
-
Installation of the side curtain airbag must be done according to precautions and procedures See: Air Bag(s) Arming and Disarming/Service and
Repair.
-
If the airbag is frayed, or has any other visible damage, replace it. Do not attempt to repair an airbag.
-
When you install the airbag, make sure it is not twisted, and that it is not caught between the inflator bracket by the bracket bolts.
-
Make sure that the side curtain airbag inflator retainer is installed properly. Otherwise the airbag could incorrectly deploy and cause damage or
injuries.
-
If there is any damage to the side curtain airbag, do not try to repair it. Replace any damaged side curtain airbag.
1. Place the side curtain airbag assembly on the side of the roof, and fit its clips (A) into the holes in the body. Tighten the side curtain airbag bolts
(B) and the bolts (C) to the specified torque.
