TL AWD V6-3.7L (2010)
Air Bag Control Module: Service and Repair
SRS Unit Replacement
SRS Unit Replacement
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before starting work.
2. Remove the center console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center
Console Removal/Installation.
3. Pull down on the center heater joint duct (A) to remove it.
4. Remove the clips (B), then remove the left and right heater ducts (C, D).
5. Remove the two screws from the driver's side center console clip bracket (A), then remove the bracket.
6. Remove the TORX bolt (A) using a TORX T30 bit.
