TL AWD V6-3.7L (2010)
7. Disconnect SRS unit connectors A (39P) and B (39P) from the SRS unit (C).
NOTE: The SRS unit connectors have lever locks. Release the locks before disconnecting the connectors See: Air Bag Systems/Air Bag(s) Arming and
Disarming/Service and Repair.
8. Remove the TORX bolts (D) using a TORX T30 bit, then remove the SRS unit from the driver's side.
Installation
1. Install the SRS unit (A) with a new TORX bolt (B) using a TORX T30 bit.
NOTE: Be sure the SRS unit is sitting squarely against it's bracket before torquing the TORX bolt.
