TL AWD V6-3.7L (2010)
5. Pull out the seat belt buckle switch harness (D) through the space between the seat cushion and the seat track.
6. Install the buckle in the reverse order of removal, and note these items:
-
Assemble the washers and the collar on the center anchor bolt as shown.
-
Before installing the center anchor bolt, make sure there are no twists or kinks in the front seat belt.
-
Tighten the bolts by hand first, then tighten to the specified torque.
-
Make sure the seat belt buckle switch connector is plugged in properly.
-
Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
-
Check for any DTCs that may have been set during repairs, and clear them.
