TL AWD V6-3.7L (2010)
Replace it if it does not slide smoothly.
17. Rotate the overrunning clutch (A) both ways. If it does not lock in either direction, or it locks in both directions, replace it.
18. If the starter drive gear (B) is worn or damaged, replace the overrunning clutch assembly; the gear is not available separately.
Check the condition of the flywheel ring gear to see if the teeth are damaged.
Starter Reassembly
19. Install the armature in the housing.
20. Set the brushes with the brush spring in the brush holder (A).
21. Place the brush holder assembly on the armature, then move the brush holder down to the armature.
NOTE: Keep the brush holder on the armature so the brushes do not come out of the brush holder.
22. Install the end cover (A) to retain the brush holder (B).
