TL AWD V6-3.7L (2010)
8. Disconnect the knuckle ball joint from the lower arm using the ball joint thread protector and the ball joint remover See: Ball Joint/Service and
Repair/Ball Joint Removal.
NOTE:
-
Be careful not to damage the ball joint boot when installing the remover.
-
Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
9. Pull the knuckle (A) outward, and separate the outboard joint (B) from the front hub using a soft face hammer.
NOTE: Do not pull the driveshaft end outward. The driveshaft inboard joint may come apart.
10. Remove the lower arm mounting bolts, mounting nuts, and the washers, then remove the lower arm (A).
NOTE: Use new lower arm mounting bolts, new mounting nuts, and new washers during reassembly.
