TL AWD V6-3.7L (2010)
9. Install the clutch line connector (A) with a new O-ring (B), then set in a new retaining clip (C) to the master cylinder (D).
NOTE:
-
Apply the silicone grease (P/N 08C30-B0234M) on the O-ring and the joint part (E) of the clutch line connector.
-
Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your
hands or gloves.
10. To prevent the retaining clip (A) from coming off, pry apart the tip (B) of the clip with a screwdriver.