TL AWD V6-3.7L (2010)
Clutch Switch: Adjustments
Clutch Pedal, Clutch Pedal Position Switch A, and Clutch Pedal Position Switch B Adjustment
NOTE:
-
For a cruise control problem, check clutch pedal position switch B See: Testing and Inspection/Clutch Pedal Position Switch B Test.
-
For a clutch pedal position switch operation problem, check clutch pedal position switch A See: Testing and Inspection/Clutch Pedal Position
Switch A Test.
-
Remove the driver's floor mat before adjusting the clutch pedal.
-
If there is no clearance between the master cylinder piston and the pushrod, the release bearing will be held against the diaphragm spring, which
can result in clutch slippage or other clutch problems.
1. Disconnect the clutch pedal position switch A connector and the clutch pedal position switch B connector.
2. Loosen the clutch pedal position switch B locknut (A), and back off clutch pedal position switch B until it no longer touches the clutch pedal (C).
3. Loosen the clutch pushrod locknut (D), and turn the pushrod (E) in or out to get the specified height (F), and the stroke (G) at the clutch pedal. If
adjusting the pushrod causes the clutch pedal to contact clutch pedal position switch B, back off the switch further.
4. Tighten the clutch pushrod locknut (A).