TL AWD V6-3.7L (2010)
2. Make marks (A) on each roller (B) and the inboard joint (C) to identify the locations of the rollers to the grooves in the inboard joint.
NOTE: Do not engrave or scribe any marks on the rolling surface.
3. Remove the inboard joint on a clean shop towel (D). Be careful not to drop the rollers when separating them from the inboard joint.
4. Remove the spider.
-
For the except SH-AWD model right side with M/T, go to step 5.
-
For the SH-AWD model right side with M/T, go to step 9.
5. Make marks (A) on the spider (B) that match the marks on the rollers, then remove the rollers.
NOTE: Do not engrave or scribe any marks on the rolling surface.