TL AWD V6-3.7L (2010)
Special Tools Required
-
Boot Band Tool KD-3191 or equivalent, commercially available
-
Seal Clamp Tool Kent-Moore J-35910 or equivalent, commercially available
-
Boot Band Pliers, commercially available
NOTE:
-
Refer to the Exploded View, as needed, during this procedure.
-
For SH-AWD model: Make sure to use silicone-type (gray) boots on the right front driveshaft inboard joint.
-
Do not reuse the removed right front driveshaft inboard joint boot.
-
Make sure to use the boot bands and the grease included in the inboard boot set or the inboard joint set.
Inboard Joint Side