TL AWD V6-3.7L (2010)
7. Remove the cotter pin (A) from the knuckle ball joint, then remove the castle nut (B). Separate the ball joint from the lower arm (C) using the ball
joint remover See: Steering and Suspension/Suspension/Ball Joint/Service and Repair/Ball Joint Boot Inspection/Replacement.
NOTE:
-
Be careful not to damage the ball joint boot when installing the remover.
-
Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
8. Pull the knuckle outward, and separate the outboard joint from the front hub using a soft face hammer.
