TL AWD V6-3.7L (2010)
10. Install a new cotter pin (E) into the ball joint pin hole, and bend the cotter pin as shown.
11. Install the damper fork (A) over the driveshaft and onto the lower arm. Install the damper in the damper fork so the aligning tab (B) is aligned with
the slot in the damper fork. Loosely install the damper pinch bolt (C).
12. Loosely install a new flange bolt (D) and a new damper fork mounting nut (E).
13. Connect the front stabilizer link (A) to the lower arm, and loosely install the flange nut (B). Hold the stabilizer link ball joint pin (C) using a hex
wrench (D), and tighten the flange nut.