TL AWD V6-3.7L (2010)
14. Place a floor jack under the lower arm, and raise the suspension to load it with the vehicle's weight.
NOTE: Do not put the floor jack under the ball joint.
15. Tighten the damper pinch bolt and the damper fork mounting nut while holding the flange bolt to the specified torque values, then remove the floor
jack.
16. Apply a small amount of engine oil to the seating surface of a new spindle nut (A).
17. Install the spindle nut, then tighten it. After tightening, use a drift to stake the spindle nut shoulder (B) against the driveshaft.
18. Clean the mating surfaces of the brake disc and the wheel, then install the front wheels.
19. Turn the front wheel by hand, and make sure there is no interference between the driveshaft and the surrounding parts.
20. Lower the vehicle .
21. Refill the transmission with recommended transmission fluid:
-
Manual transmission See: Manual Transmission/Transaxle/Fluid - M/T/Service and Repair
-
Automatic transmission See: Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/ATF Replacement
22. Check the wheel alignment, and adjust it if necessary See: Maintenance/Alignment/Service and Repair.