TL AWD V6-3.7L (2010)
14. Attach the windshield molding (A) with adhesive tape (B) to the upper edge of the windshield (C). Be careful not to touch the windshield where
the adhesive will be applied.
15. Attach the molding upper seal (A) with adhesive tape to the inside surface of the windshield molding (B) as shown.
16. Set the windshield in the opening, and center it. Make alignment marks (A) across the windshield and the body with a grease pencil at the four
points shown. Make sure the pins (B) of both upper clips (C) contact with the edge of the body holes. Be careful not to touch the windshield where
the adhesive will be applied.
