TL FWD V6-3.5L (2009)
NOTICE:
If you pull the speaker out too far from the rear bulkhead, you will damage the lower clips.
3. Disconnect the 2P connector (B), and remove the rear speaker.
4. Measure the resistance between the terminals No. 1 and No. 2:
-
With navigation, there should be 2 Ohms.
-
Without navigation, there should be 4 Ohms.
5. If the resistance is not as specified, replace the rear speaker.
Rear Door Speaker (with ELS audio system)
1. Remove the rear door panel. See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair/Rear Door
Panel Removal/Installation
2. Remove the bolts, disconnect the 2P connector (A), and remove the speaker (B).
3. Measure the resistance between terminals No. 1 and No. 2. There should be about 2 Ohms.
4. If the resistance is not as specified, replace the rear door speaker.
Subwoofer
1. Remove the rear shelf. See: Body and Frame/Interior Moulding / Trim/Rear Shelf/Service and Repair
2. Remove the four mounting bolts from the subwoofer (A).
3. Disconnect the 2P connector (B), and remove the subwoofer.
4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 2 Ohms.
5. If the resistance is not as specified, replace the subwoofer.
