TL FWD V6-3.5L (2009)
6. Pass the front seat belt (A) lower anchor out through a hole in the slider (B), then remove the B-pillar upper trim (C).
7. Install the trim in the reverse order of removal, and note these items:
-
If the clip (A) is damaged or stress-whitened, replace it with a new one.
-
If the side curtain airbag has deployed, replace the B-pillar upper trim, the B-pillar lower trim, and the clips on the trim with new parts. See:
Restraint Systems/Air Bag Systems/Service and Repair
-
To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect the trim and replace it if it has any of the
following damage:
-
Any cracks or deformations in the B-pillar upper trim (B) or the upper hooks (C), or any stress-whitened areas in the upper part of the trim
-
Any cracks or deformations in the B-pillar lower trim (D), or any breakages in the part (E) that overlaps the B-pillar upper trim
-
Any cracks or stress-whitened areas in the clip seating surface (F)
-
Replace any damaged parts with new ones.
-
Make sure the top of the trim overlaps with the headliner correctly. See: Restraint Systems/Air Bag Systems/Service and Repair
-
Make sure the pin (G) on the front seat belt shoulder anchor adjuster (H) and the hole (I) on the back of the slider are engaged when installing
the B-pillar upper trim.
-
Make sure the upper hooks are installed into the holes in the body securely.
-
Push the clips and the hooks into place securely.