TL FWD V6-3.5L (2009)
Power Seat Motor: Testing and Inspection
Driver's Power Seat Motor Test
Driver's Power Seat Motor Test
1. Remove the driver's seat. See: Service and Repair/Front Seat Removal/Installation
2. Disconnect the connector from each power seat motor.
NOTE:
-
For the recline motor, remove the seat-back cover. See: Seat Cover/Service and Repair/Front Seat-Back Cover Replacement
-
All connectors are terminal side of male terminals.
3. Test each motor by connecting power and ground according to the table. When the motor stops running, disconnect battery power immediately.
4. If the motor does not run or fails to run smoothly, replace:
-
Slide motor See: Service and Repair/Front Seat Slide Motor Replacement
-
Front up-down motor See: Service and Repair/Front Seat Frame Replacement
-
Rear up-down motor See: Service and Repair/Front Seat Frame Replacement
-
Recline motor See: Service and Repair/Front Seat Recline Motor Replacement
NOTE: The front and rear up-down motors are part of the seat frame.
