TL FWD V6-3.5L (2009)
23. Tighten the bearing cap bolts, and then the bearing cap side bolts to the specified torque in the sequence as shown. Repeat the torque sequence
again to ensure the bolts are properly torqued.
24. Remove all of the old liquid gasket from the engine block end cover mating surfaces, the bolts, and the bolt holes.
25. Clean and dry the engine block end cover mating surfaces.
26. Apply a light coat of new engine oil to the lip of the crankshaft oil seal.
27. Using the driver handle and the oil seal driver attachment, drive in the new crankshaft oil seal until the oil seal driver attachment bottoms on the
engine block end cover.
28. Apply liquid gasket, P/N 08717-0004, 08718-0001, 08718-0003, or 08718-0009, evenly to the engine block mating surface of the engine block
