TL FWD V6-3.5L (2009)
Air Register: Service and Repair
Dashboard Center Vent Removal/Installation
Dashboard Center Vent Removal/Installation
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
NOTE:
-
Take care not to scratch the dashboard or the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Carefully pull one side of the dashboard center vent (A) partially out to release clips (B, C) and the hooks (D), then do the same on the other side.
Disconnect the hazard warning switch/passenger airbag cutoff indicator connector (E), then remove the dashboard center vent.
2. Install the dashboard center vent in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips and the hooks into place securely.
-
Make sure the connector is plugged in properly.
