TL FWD V6-3.5L (2009)
Air Register: Service and Repair
Passenger's Side Vent Removal/Installation
Passenger's Side Vent Removal/Installation
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
NOTE:
-
Take care not to scratch the dashboard or the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove these items:
-
Center trim See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Dashboard Center Trim
Removal/Installation
-
Passenger's dashboard trim See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Passenger's
Dashboard Trim Removal/Installation
-
Glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove Box Removal/Installation
2. Remove the screw (A) securing the duct (B) from glove box opening. Remove the screws (C) securing the passenger's side vent (D).
3. Pull out passenger's side vent (A) to detach the clip.
4. Install the vent in the reverse order of removal, and note these items:
-
If the clip is damaged or stress-whitened, replace it with a new one.
-
Push the clip into place securely.