TL FWD V6-3.5L (2009)
Data Link Connector: Testing and Inspection
DLC Circuit Troubleshooting
NOTE: Make sure the HDS and the HDS DLC cable are not defective.
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Connect the HDS to the DLC. See: Testing and Inspection/Initial Inspection and Diagnostic Overview
NOTE: Make sure the HDS is properly connected to the DLC.
3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and read the HDS.
Does the HDS identify the vehicle?
YES - Go to step 4.
NO - Go to step 25.
4. Check for Pending or Confirmed DTCs in the PGM-FI system with the HDS.
Are any Pending or Confirmed DTCs indicated?
YES - Go to the indicated DTC's troubleshooting.
NO -
-
If the HDS does not communicate with the SRS system, go to step 5.
-
If the HDS does not communicate with the VSA system, go to step 7.
-
If the HDS does not communicate with the EPS, go to step 9.
-
If the HDS does not communicate with the SH-AWD system, go to step 11.
-
If the HDS does not communicate with the TPMS, go to step 13.
-
If the HDS does not communicate with the IMMOBI (immobilizer) system, go to step 15.
-
If the HDS does not communicate with the BODY ELECTRICAL system, go to step 17.
5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
6. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and watch the SRS indicator.
Does the SRS indicator stay on?
YES - Go to the SRS system's general troubleshooting information. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial
Inspection and Diagnostic Overview
NO - Go to step 19.
7. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
8. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and watch the VSA indicator.
Does the VSA indicator stay on?
YES - Go to the VSA system's general troubleshooting information. See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview
NO - Go to step 19.