TL FWD V6-3.5L (2009)
Installation
1. Install the SRS unit (A) with a new TORX bolt (B),using a TORX T30 bit.
NOTE: Be sure the SRS unit is sitting squarely against it's bracket before torquing the TORX bolt.
2. Install the new TORX bolts (A) using a TORX T30 bit.
3. Connect the connectors (B) to the SRS unit; push them into position until they click and the lever locks are fully secured. See: Air Bag(s) Arming
and Disarming/Service and Repair
4. Install the driver's side center console clip bracket (A) with two screws.
