TL FWD V6-3.5L (2009)
5. Remove the brake caliper bracket mounting bolts (B), then remove the caliper assembly (C) from the knuckle. To prevent damage to the caliper
assembly or the brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage. Do not twist the brake hose excessively.
6. Remove the two washers (A).
NOTE: During installation, make sure the washers are installed between the brake caliper bracket and the knuckle.
7. With SH-AWD: Raise the stake (A), then remove the spindle nut (B).
8. Remove the rear brake disc/drum. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Rear Brake Disc
Replacement
9. Without SH-AWD: Remove the hub bearing unit (A) and the O-ring (B).