TL FWD V6-3.5L (2009)
Shifter A/T: Removal and Replacement
A/T Shift Lever Installation
A/T Shift Lever Installation
1. Install the shift lever assembly (A).
2. Connect the shift lever 4P connector (B).
3. Install the shift lever 4P connector on the shift lever bracket base (C).
4. Push the shift cable (A) until it stops, then release it. Pull the shift cable back one step from the P position so that the shift position is in R. Do not
hold the shift cable guide (B) to adjust the shift cable.
5. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the R position indicator comes on.
6. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
7. Place the shift lever in R, then insert a 6.0 mm (0.24 in.) pin (A) into the positioning hole (B) on the shift lever positioning guide, and into the