TL FWD V6-3.5L (2009)
positioning hole on the shift lever bracket. Use only a 6.0 mm (0.24 in.) pin with no burrs.
8. Align the shift cable slot (A) between the socket holder (B) and the socket holder retainer (C) with the opening (D) in the shift cable bracket (E),
then slide the holder into the bracket while installing the shift cable end (F) over the mounting stud (G) by aligning its square hole with the square
fitting (H) at the bottom of the stud. Do not install the shift cable by holding the shift cable guide (I).
NOTE: When the socket holder is installed in the shift cable bracket, the retainer lock is unhinged and releases the holder retainer lock, then the
holder retainer returns under spring force to secure the shift cable.
9. Push the retainer lock (A) fully to lock the socket holder retainer (B), and make sure that the retainer lock fits into the hinged-joint (C). If the
retainer lock does not fit with the edge of the hinged-joint, rotate the holder retainer counterclockwise while pushing the retainer lock until it locks.
10. Check that the shift cable end is properly installed on the mounting stud.
