TL FWD V6-3.5L (2009)
Shifter A/T: Testing and Inspection
Paddle Shifter + (Upshift Switch) Illumination Circuit Troubleshooting
Paddle Shifter + (Upshift Switch) Illumination Circuit Troubleshooting
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair in
the SRS before doing repair or service.
1. Remove the steering wheel. See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Removal and Replacement/Steering Wheel
Removal
2. Check for continuity between cable reel subharness 20P connector terminals No. 18 and No. 19.
Is there continuity?
YES - Go to step 3.
NO - Go to step 10.
3. Remove the cable reel. See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair
4. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and turn the lighting switch ON.
5. Measure the voltage between cable reel 20P connector terminals No. 18 and No. 19.
Is there battery voltage?
YES - Replace the cable reel. See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair
NO - Go to step 6.
6. Measure the voltage between cable reel 20P connector terminal No. 19 and body ground.
Is there battery voltage?
YES - Go to step 7.
NO - Check for a blown No. 6 (7.5 A) fuse in the passenger's under-dash fuse/relay box. If the fuse is OK, repair open or short in the wire
between cable reel 20P connector terminal No. 19 and the passenger's under-dash fuse relay box.