TL FWD V6-3.5L (2009)
Axle Shaft Assembly: Overhaul
Front Driveshaft Disassembly
Front Driveshaft Disassembly
Special Tools Required
-
Threaded adapter, 26 x 1.5 mm 07XAC-001030ASlide hammer, 5/8" x 18 UNF, commercially available
-
Puller, commercially available
-
Boot band pliers, commercially available
Inboard Joint Side
1. Remove the boot bands. Be careful not to damage the boot.
-
If the boot band is a welded type (A), cut the boot band.
-
If the boot band is a double loop type (B), lift up the band end (C), then push it into the clip (D).
-
If the boot band is a low profile type (E), pinch the boot band using commercially available boot band pliers (F).
Welded type
Double loop type
Low profile type