TL FWD V6-3.5L (2009)
3. Install the spider (A) onto the driveshaft by aligning the marks (B) you made on the spider and the end of the driveshaft.
4. Install a new circlip (C) into the driveshaft groove. Always rotate the circlip in its groove to make sure it is fully seated.
5. Fit the rollers (A) onto the spider (B) as shown, and note these items:
-
Reinstall the rollers in their original positions on the spider by aligning the marks (C) you made.
-
Hold the driveshaft pointed up to prevent the rollers from falling off.
6. Pack the inboard joint with the joint grease included in the new inboard boot set.
Grease quantity (Inboard joint)
