TL FWD V6-3.5L (2009)
16. Lift up the boot band tool to bend the free end of the band 90 degrees to the clip. Center-punch the clip, then fold over the remaining tail onto the
clip.
17. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5-10 mm (0.2-0.4 in.) tail protruding from the clip.
18. Bend the band end (A) by tapping it down using a hammer.
NOTE:
-
Make sure the band and the clip do not interfere with anything on the vehicle, and the band does not move.
-
Clean any grease remaining on the surrounding surfaces.
19. Repeat step 11 through 18 for the band on the other end of the boot.