TL FWD V6-3.5L (2009)
9. Remove A/T clutch pressure control solenoid valves A and B, the ATF pipes (C), the gasket (D), and the O-rings (E).
10. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust or dirt, and clean the passage.
11. Install a new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
12. Install A/T clutch pressure control solenoid valves A and B.
13. Install the harness cover on its bracket, and secure it with the bolt.
14. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
15. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the selector control lever, then insert the
control pin into the selector control lever hole through the shift cable end, and secure the control pin with the spring clip.
16. Secure the shift cable bracket with the nuts.
17. Install the battery base. See: Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/Automatic Transmission
Installation
18. Install the air cleaner assembly. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service
and Repair
19. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
