TL FWD V6-3.5L (2009)
Pressure Regulating Solenoid: Service and Repair
A/T Clutch Pressure Control Solenoid Valve C Replacement
A/T Clutch Pressure Control Solenoid Valve C Replacement
1. Do the battery removal procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
2. Remove the air cleaner assembly. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair
3. Disconnect the A/T clutch pressure control solenoid valve C connector (A).
4. Remove A/T clutch pressure control solenoid valve C, the ATF joint pipes (B), the O-rings (D), the ATF pipe (E), and the gasket (F).
5. Clean the mounting surfaces and the fluid passages of the solenoid valve body and the transmission housing.
6. Install the 8 x 53 mm ATF joint pipe (A) with the filter end into its mounting hole (B).
7. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and the solenoid valve body mounting surface (D). The
height is about 7.0 mm (0.3 in.). If the height is over 7.0 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.
