TSX L4-2.4L (2005)
6. Release the hooks (A) of the lock cable protector (B) from the door, then remove the latch (C) (with the protector) through the hole in the door.
Take care not to bend the outer handle rod (D), cylinder rod (E), lock cable (F), and inner handle cable (G).
7. Remove the lock cable protector (A) from the latch protector (B) by releasing the hook (C).
8. Install the latch in the reverse order of removal, and note these items:
-
Make sure the actuator connectors are plugged in properly and each rod is connected securely
-
Make sure the door locks and opens properly
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Driver's: Perform the power window control unit reset procedure.
