TSX L4-2.4L (2005)
Rear Door Panel: Service and Repair
Rear Door Panel Removal/ Installation
Special Tools Required
-
KTC trim tool set SOJATP2014*
-
Trim pad remover. Snap-on A 177A or equivalent, commercially available
*
Available through the American Honda Tool and Equipment Program; call 888-424-6857
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Lower the glass fully.
2. Using a trim tool, push on the rear hook (A) and pivot the cover (B) on the front hook (C), then remove the cover and the screws securing the inner
handle (D).
3. Remove the switch panel (A).
1. Pry up on the front edge of the switch panel with a trim tool to release the front clip.
2. Pull out along the edge of the panel to release the hooks (B) and clip.
3. Disconnect the power window switch connector (C).