TSX L4-2.4L (2005)
4. Pry out the front lower edge of the grip cover (A) at a gap between the cover and the grip base (B) to release the hooks (C), then pull out the cover
to release the upper hooks (D) and remove the cover.
5. Remove the screws from the grip base.
6. Remove the door panel (A) with as little bending as possible to avoid creasing or breaking it.
1. Starting at the bottom edge of the door panel, release the clips (B) that are just above the marks (C) on the edge of the panel with a
commercially available trim pad remover.
2. Detach the upper clips (D, E).
3. Starting at the rear, pull the door panel upward and over the lock knob (F).
NOTE: The inner handle cable (G) is connected to the inner handle (H). Do not pull the door panel up too far, or the inner handle cable will
be damaged.
7. Disconnect the inner handle cable (A). If necessary, remove the inner handle (B) by releasing the hooks (C, D).
