TSX L4-2.4L (2005)
Scuff Plate: Service and Repair
Trim Removal/Installation - Door Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
Front Door Sill Area
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to , avoid damage when prying components.
1. Left side: Remove the footrest.
2. Left side: Remove the front side cap from the front door sill trim, and remove the opener lock cylinder and bolt.
3. Detach the hooks (A) and tabs (B) from the kick panel (C) and B-pillar lower trim (D), and pull the front door sill trim (E) up by hand to detach
the clips (F, G), then remove it.
4. Disconnect the trunk lid opener/fuel fill door opener cable (H) from the opener (I).
5. If necessary, pull the front side outer trim (J) up to detach the clips (K), then remove the trim.
6. Remove the left kick panel (A) or the right kick panel (B).
1. Pull out the door opening trim (C) as needed from the kick panel hooks (D) and the door opening flange.
