TSX L4-2.4L (2005)
-
If the side curtain airbag has deployed, replace the A-pillar trim with a new one.
-
To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect removed pieces and replace them if they
have any of these types of damage:
-
Any cracks, deformations, or stress-whitened areas in the A-pillar trim (A)
-
Any cracks, or stress-whitened areas in the grommet and clip seating surfaces (B)
-
Bent or broken grommet (C)
-
Replace any damaged parts with new ones.
-
Make sure the top of the trim overlaps with the headliner correctly.
-
Push the clips into place securely.
B-pillar
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove these items:
-
Front door sill trim.
-
Rear door sill trim.
-
Front door opening trim, as needed.
-
Rear door opening trim, as needed.
2. Remove the B-pillar lower trim (A).
1. Detach the lower clips by pulling the bottom of the trim back by hand.
2. Pull the trim down to release the upper hooks (B).
3. Remove the upper anchor cover, and remove the upper anchor bolt.
